Bed Type Milling Machine - Universal PARPAS SHARK One

Produkt plats

Tillverkare

Beskrivning

x-travel 3500 mm
y-travel 1083 mm
z-travel 1074 mm
control HEIDENHAIN iTNC 530 HSCI
clamping table -
surface area 4.000 x 1.000 mm
Thread bore with fitting -
Feeds -
X-, Y- and Z-axis, stepless 2 - 30.000 mm / min
rapid travel x / y / z 30 m / min
Max. feed force of axis 10.000 N
2-axis Milling Head -
2-axis milling head TUB-E92 with power on -
Torque-Motors for 5-axis-simultaneos processing -
capacity at 100% load 29 kW
Speed stepless 2- 30.000
max. torque 92 Nm
Max. torque 60 min-1
tool taper HSK 62A-DIN 69893
automatic tool changer ATC -
Tool places 30
diameter of tools max. 90 mm
workpiece length 320 mm
weight of tools max. 8 kg
changing positions vertikal
electrical supply data -
capacity 120 A
voltage 400 V
operating frequency 50 Hz
total power requirement 29 kW
weight of the machine ca. 28 t
dimensions of the machine ca. 8,3 x 6,7 x 3,6 m
Equipment
? Machine bed, column and vertical saddle as welded steel construction,
annealed with low tension
? Milling slider as welded steel construction
? Orthogonal milling head TUB-E92 with motor spindle, C- and A-axis drive
via torque motors
? Oil cooling unit for cooling the milling head
? CNC thermal compensation
? Spindle drive 29 kW
? Spindle speed max. 18.000 min-1
? Axle drives by means of precision ball screws and digital servo motors
? Touch probe system manufacturer BLUM, TC 63-30 with radio transmission and
automatic measuring cycles
? Milling head Measurement ?Kinematics Opt?
? Laser tool presetter BLUM - NT version mounted on machine table
? CNC control HEIDENHAIN iTNC 530 HSCI incl. digital drive technology
? Portable electronic handwheel HEIDENHAIN HR 520 with 3 m spiral cable
? swivelling control panel for machine operation in front of the machine
? Automatic tool changer with 30 magazine places, change position vertical
? Coolant system with external shower rim and IKZ through the spindle
? 1 chip conveyor in the working area, ejection right
? Pretensioned linear guides in all axes
? Precision ball screws in Y- and Z-axis
? X-axis drive via gear rack and master / slave drive
? Hydraulic weight compensation in the vertical axis
? Bellows cover of the X-axis
? Milling slide above and below in the vertical axis with bellows covers
with attached stainless steel lamellas closed
? Work area enclosure closed on all sides. Back side of the work area with
bellows cover with attached stainless steel lamellas closed. The manual sliding
doors on the front of the machine can be opened and closed over the entire
length of the table.
Safety fencing for the back machine area with two secured access doors.
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

Condition

Byggår

Maskin under ström